Breadboard and Jumper Wires

There are 4 products in this section
Sort by Name | Date | Price     Ascending | Descending

Breadboard

The best way to experiment with the Arduino/Genuino Uno or Mega and electronic components in general is to use a breadboard. A breadboard allows you to quickly connect components and wires to each other without soldering.

£2.49

Jumper Wire

These wires can connect directly to your Arduino/Genuino Uno or Mega, or a breadboard, without soldering using the pins attached to them.

£0.39
Available in 2 lead lengths and 6 colours

Jumper Wire to Socket

These wires can connect directly to your Arduino/Genuino Uno or Mega, or a breadboard, without soldering using the pins attached to them. At the other end of the wire is a socket in which you can insert other pins.

This is useful if you need to connect several devices to the 5V or GND pins of your Arduino/Genuino Uno, but don’t want to use a breadboard.

£1.59 – £1.69
Available in 2 sizes and 2 colours

MECControl Starter Pack

Get started with MECControl the easy way! This pack contains the MECControl software, an Arduino/Genuino-compatible Uno R3 board with the MECControl firmware pre-installed, microswitches, leads and an L298 H Bridge module for motor control.

£24.99